Installation requirements for DC power cables

1.The voltage of the strip is usually 12V dc power line. If you do not want each LED strip to be controlled by the power supply, you can buy a high power switching power supply as the main power supply, and then all the LED lights are connected to the input power supply in parallel (the wire size is not enough for additional extension), unified by the main switching power supply.Its advantage is that it can be centralized control, the inconvenience is that it can not realize the lighting effect and switch control of single LED strip lamp, the specific way can be measured by itself.

2.Each meter has a “scissors” mark that can only be cut when the mark is cut.If the mark is cut wrong or cut off, one meter will not be bright! It’s best to look at the mark carefully before cutting in the middle where there is no connection.

3. Each light belt must be equipped with a special plug (plug with transformer), the transparent plastic cover must be removed when connecting, and then the light belt is covered. Be sure not to connect directly to the lid, it is easy to short circuit!

4. Outdoor installation: Outdoor installation will be exposed to wind and rain. If fixed with 3M glue, 3M glue will be reduced, and the LED strip will fall off after a long time. Therefore, the card slot is often used for outdoor installation.

5. Indoor installation: LED light belt is used for indoor decoration, because it does not need to withstand wind and rain, so it is very simple to install.Take the common LED light belt as an example, each LED light belt has a 3M self-adhesive double-sided tape on the back. You can directly remove the stickers on the surface of the 3M self-adhesive double-sided tape, and then fix the lamp belt to be installed with your hand flat on it. As for what needs to be turned or planted in some places? Very simple, LED light strip is a series and parallel 3-way LED for a group of circuit structure, each 3-way LED can be cut off separately.

6. When installing the optical tape, the optical tape is usually placed in the optical slot and arranged in a straight line. It can also be secured with string or wire. For external or vertical installations, “clips” and “tail plugs” need to be configured.

12650355893_1797863070

 

Contact information: [email protected]

 


Post time: Dec-28-2021